Lesson 11 · 15 min

The pedals

The sustain, soft and sostenuto pedals, how to press them, the pedal marks, and changing the pedal cleanly after each chord.

Open this lesson in dacapo

In the app the figures sound and answer to your keyboard, and the exercises check what you play.

A grand piano has three pedals, and the right one is used in nearly every piece written since Chopin’s time. Used well, it joins what the hands cannot and makes the piano ring; used carelessly, it smears everything together. This lesson shows what each pedal does and how to change the right one cleanly.

Three pedals

  • Right: the sustain pedal, also called the damper pedal. It lifts every damper off the strings at once, as Inside the piano shows: notes ring on after you let go of the keys, and other strings ring along with them. It is the one most music means by “pedal”.
  • Left: the soft pedal, or una corda (“one string”). On a grand it slides the whole action a little sideways, so each hammer strikes fewer strings: the sound is quieter and softer in colour. Tre corde (“three strings”) tells you to let it up. On an upright it moves the hammers nearer the strings, which only makes the notes quieter.
  • Middle: the sostenuto pedal, on most grands. It holds up only the dampers that are already raised when you press it: play a bass note, press the middle pedal, and that note rings on while everything after it stays clear. On many uprights the middle pedal is instead a practice pedal, which lowers a strip of felt between hammers and strings to play very quietly.

Most digital pianos have a sustain pedal, and some have all three. A MIDI keyboard sends its sustain pedal to this app, as it does its keys.

How to press it

  • Use your right foot, with the heel on the floor in front of the pedal.
  • Press with the ball of the foot, moving from the ankle, and keep the foot on the pedal when it comes up, so it never slaps or thumps.
  • Press it all the way down, and let it all the way up: halfway does neither job.
  • Keep the left foot flat on the floor, or near the soft pedal when you need it.

Pedal marks

The sustain pedal is marked under the bass staff. Older scores write Ped. where it goes down and a star, ✱, where it comes up. Newer ones draw a line: it starts where the pedal goes down, and each notch in it is a change, up and straight down again. Where a score marks nothing, the pedal is often still expected, and it is up to you and your teacher.

Plate The same pedalling written two ways: down at the first chord, changed at each new one, up at the end.

Changing the pedal: legato pedalling

To join one chord to the next, the pedal has to let go of the old chord and catch the new one, with no gap and no blur. The trick is to change it after the new chord, not with it: play the new chord, then lift the pedal and press it straight down again while you hold the keys. The dampers fall for a moment and silence the old chord, and the new one, still held by your fingers, is caught by the pedal.

The foot moves just after the hands, never together with them: this is called legato or syncopated pedalling. Lift the pedal before the new chord and the sound breaks, a gap; lift it too late and the old chord rings into the new one, a blur.

Up just after each chord and straight down again: every chord rings into the next, each on its own.

KeysPedalSound
Plate Watch four chords with the pedal changed in time, too early and too late: keys at the top, the pedal in the middle, what you hear at the bottom. Play chords with your own keyboard and pedal, and it follows you.

When to change it

Change the pedal whenever the harmony changes, usually with each new chord in the bass. Keep it down through one harmony and the notes ring together as they should; keep it down into the next and the two chords blur.

The hand has to leave each chord to reach the next: gaps between them.

Plate The four chords played without the pedal, with it held all the way through, and changed at each chord. Only the last joins them and keeps them clear.

Advanced players also lift the pedal only partway, so the dampers just brush the strings: this half pedalling thins the sound without stopping it.

Leave the pedal up, or nearly, where it would muddy the music:

  • in Bach and most music of his time, where the fingers do the joining;
  • in fast scales and runs, whose notes would pile up into a smear;
  • on staccato notes, which the pedal would make long again.

When in doubt, listen: if the sound is muddy, change more often, or less deeply.

Try it: four chords

Play the four chords with your right hand, changing the pedal after each: press it after the first chord, then for each new chord, play, up, down. A change is clean when the pedal comes up within a quarter of a second of the chord and goes down again within 0.4 seconds. This needs a sustain pedal plugged into a MIDI keyboard.

This exercise is played in the app.

Test yourself

This exercise is played in the app.

On Play, the keys held by the pedal stay lit, so you can see what is still ringing. Try the chords of any piece there, changing the pedal with each.